• Oli Natura Linseed Oil Varnish
  • Oli Natura Linseed Oil Varnish
  • Oli Natura Linseed Oil Varnish

Oli Natura Linseed Oil 1L

Reference: A04266_RF
€18.95 per piece
€18.95 L
incl. VAT excl. shipping costs

1L

Film-forming impregnating oil based on linseed oil.

  • Film-forming protection
  • Coverage: approx. 12–16 m²/L per coat
  • 1–3 coats recommended
  • Classic linseed oil formula

Delivery within 1-3 workingdays in Germany, in EU 6-8 workingdays

Oli Natura · Linseed Oil

Oli Natura Linseed Oil Varnish

A classic film-forming impregnating oil based on linseed oil, used to protect and enrich wood surfaces indoors and out.

Why choose it

  • Film-forming formula for lasting protection
  • Based on traditional linseed oil
  • Coverage approx. 12–16 m² per litre and coat
  • Simple to apply with a brush or cloth

Pack size

  • 1L

Good to know

  • Apply 1–3 coats depending on absorbency
  • Allow adequate drying time between coats
  • Wipe off any excess after application
Tip: A traditional choice for enriching the natural tone of the wood.
  • Price suffix
    per piece
  • Consumption
    60-80 ml/m²
  • Drying times
    16-24 Hours
  • Manufacturer
    OLI NATURA
  • *
    At 20° C and 65 % relative humidity, depending on the type of floor covering and the absorbency of the substrate.

Oli Natura Linseed Oil Varnish – Application Instructions

  • ✓ The surface must be finely sanded and free of dust and grease.
  • ✓ Shake the container well or stir thoroughly before use.
  • ✓ Apply the oil thinly and evenly with a brush or a lint-free cotton cloth, following the direction of the grain. Dry spots can be re-oiled directly as needed.
  • ✓ Within 30 minutes, excess oil should be removed with an oil-absorbing cloth or cotton cloth and the surface carefully buffed. It should then feel dry to the touch.
  • ✓ After a drying time of 16 to 24 hours, a further coat can be applied if needed.
Important note: Linseed oil varnish that has not been absorbed forms wet, glossy residue after about 30 minutes. This excess must be removed while still wet, otherwise it will dry significantly more slowly, stay tacky for a long time, and cause unwanted differences in sheen.

Coverage

60–80 g/m²
per coat (depending on surface absorbency)
1–3
coats recommended
12–15 m²/L
yield

Drying

Depending on humidity and temperature, the treated surface is dust-dry after 1–2 hours and can be recoated after 16–24 hours.
Full curing takes place after approximately 21 days – please treat the surface gently during this time.

⚠️ Risk of Self-Ignition Cloths or pads soaked in oil can self-ignite due to heat build-up! Therefore, wash them out immediately after use or store them airtight in water. The product itself is not self-igniting.