Loba WaxCleaner 1L

Loba Wax Cleaner 1L

Product advantages:

• Leaves a light protective film of wax
• Very economical concentrate
• Material-friendly and pH-neutral
• Good cleaning effect
• Can be used universally on various oiled surfaces

Processing instructions:
Remove loose dirt and dust with a vacuum cleaner, broom or mop beforehand.
Observe general and, if applicable, product-specific occupational health and safety regulations.
Shake the material well.

Thinner / Mixing: Water.

Application device / material consumption
LOBA mop. Use a suitable flat mop or scrubber/vacuum machine on large areas. / Depending on the area of application, add approx. 200 - 1000 ml to a bucket with 10 liters of water, sufficient for 100m². In the case of heavy soiling, the dosage can be correspondingly higher.

Drying time: approx. 60 minutes.

Application:
Initial care:
If initial care with a LOBA NatureWax or Parquet Wax is not possible, add 1l of WaxCleaner to 10l of water and use it to wipe the floor coverings that have been cleaned after construction or have been thoroughly cleaned. After drying, the surface can be polished.

Maintenance cleaning (manual):
Add 200-300ml WaxCleaner to 10l water and use it to wipe the floor coverings with a mop. Allow residual moisture to dry.

Maintenance cleaning (mechanical):
Add 200-300ml of WaxCleaner to 10l of water and wipe the floor coverings with a scrubber-vacuum machine. Immediate suction should be avoided so that the residual moisture on the surface can dry and a sufficient care effect can be achieved.

Danger:
The surface must not be flooded with the cleaning solution. The use of too much water in connection with too long an exposure time can cause swelling in parquet, wooden floors and cork coverings and must therefore be avoided.

Required water quantity:	200-300ml WaxCleaner to 10l water
Ready for foot traffic/ can be skimmed over:	nach 4-6 Stunden
Drying times:	60 Min.